About NIC (Neuroelectrics Instrument Controller)

From Neuroelectric's Wiki
Revision as of 14:16, 21 March 2016 by Xenia.martinez (talk | contribs)
Jump to: navigation, search

NIC (the Neuroelectrics Instrument Controller engine) is the software that controls StarStim and Enobio 8/20/32 NECBOX systems (the NECBOX is the little box hosting the amplifiers, electronics, battery and communications sub-systems). NIC provides access to EEG data (raw, power spectra, filters, scalp maps) as well as configuration of stimulation sesssion parameters and rendering of associated Electric fields.

Neuroelectrics has recently released a new NIC software version, 1.4. See NIC's user manual in our Download Area.

Here are some useful resources you should also check: 

- | StarStim tCS EEG recording (Jove)

- | A short introduction to NIC v1.2

- | Stimulation configuration with NIC v1.2


The features in the NIC 1.2 release include:

New features for StarStim use:

Montage definition, independent control of currents at each electrode (tDCS, tACS, tRNS or linear combinations)
Save and load montage templates
Check impedances prior launch; Visualize currents and Voltages online; Online impedance check
Program sessions including PreEEG, Stimulation and PostEEG configuration for easy experimental setup
3D Electric Field (EF) simulations - Choose your tCS montage, visualize your 3D EFs instantly on the cortex or white matter surfaces

See also our video for stimulation configuration

New features applicable to both Enobio and StarStim:

EEG and accelerometry (3 axis) raw data
EEG filters (standard EEG bands or custom band)
PSD, Spectrograms
Real-time EEG 3D Scalp Map
New EEG online power features representations 
 - Power Bars, 
 - Temporal Evolution of a power features, 
 - Improved Resolution of Power Spectrum Diagram & Spectrogram
 - Online EEG signal quality indication (based on: signal offset, signal noise, and signal drift)
SD card support for EEG/accelerometry recording in "holter" mode 
Stream EEG data over TCP/IP. Receive markers via TCP/IP for ERP related studies
Control NIC and your device with Matlab using our  MatNIC toolkit